Smart Kegerator

Discovery Channel Canada’s “Daily Planet” segment: (very similar to the walkthrough above)

Update 7/31/2015:

New installation guide has been posted here:


The purpose of this project was to allow my roommates and friends to be able to drink as much beer from the kegerator as they’d like, without guesstimating who owes what when it comes time to refill the kegs. The system uses two flow meters in the beer lines to detect when beer is poured, and once a pour has started, the raspi camera module turns on to run facial recognition (disabled when I shot this video) and charge the appropriate user for their beer. I wanted the system to be as passive as possible, requiring zero human interaction (no RFID cards, no selecting the user every time) but to record all pours and how much was poured. So far the system is running great, minus that accidental spill because my tap handles are too close together 🙂

Eventually I’d like to use weight sensors under each keg to get a better estimation of keg volume, and use a liquid probe thermometer to better estimate the temperature of the beer instead of the air. I’m also moving to a NOIR pi camera module after finding it had much better low light performance, and I’ll probably add some IR lamps to help illuminate the face for recognition when the lights are off. I also need to mount the camera a bit better, ideally higher and a littler further behind the tower, but the flex arm tripod worked great for this first implementation.

I’m also working on a new UI that will probably look something like this:

Mock up UI v2

Mock up UI v2

The source is currently avilable at but it’s certainly not finished or polished.

The UI is written in QT and C++, using python scripts for the gpio flow interrupts (the c++ interrupts seemed unreliable,but python’s implementation worked perfectly) and the C loldht script found on these forums to read the temp from the temp/humidity sensor.

I’ve made a quick and dirty fritzing image to illustrate the connections, but I’m not very good with frizing so I’ve included text as well.
On each flow meter, I connected the red to the pi’s 3.3v, black to ground, and the yellow pin to GPIO #23 and GPIO #24 for left and right sides respectively.
The temperature sensor, looking at the front of it (the side with the holes) the pins go left to right 1-4. Pin 1 to GPIO #17, so that I can turn it on/off by writing power out on pin 17. Pin 2 to GPIO #4. Pin 3 to ground. And lastly put a 4.7k ohm resistor between pins 1 and 2.

Rasperry pi

Mimo 720S display

Powered USB Hub

DHT22 temp/humidity sensor

Flow meters

Pi Camera module (NOIR seems ideal for low light)

100cm SPI cable (raspi camera cable)

Camera housing

Wide-angle lens

Techflex cable sleeve(I think it makes the raspi camera cable better looking)

For the gpio breakout:
10 pin ribbon cable

10 pin connectors

protoboard from radioshack

Mimo 720S solution –
Raspberry pi camera to opencv/facial recognition –

More info coming soon!